After trying to clear the CMOS multiple times again, what I found that worked was to remove the CMOS battery and hold in both the power and reset button for about 30 seconds. First time popped a message that defaults were loaded. attempted to load the XMP profile with my G.SKILL DDR4 3000 memory, failed both times. XMP profile fails to load (BIOS 1.3 AND BIOS 1.4)Īs another review stated, BIOS 1.3 fixed his XMP issue with G.SKILL DDR4 3200 memory. At this point I thought I was going to have to RMA the board but I figured I'd remove the battery for several hours. Removed the CMOS battery for about 15 minutes. I jumped both of them (at different times) for about 15 seconds (manual says 5 to 10).

Well there are TWO jumpers to the right of the CMOS battery and neither are labeled. The manual indicates the CMOS clear jumper is labeled JBAT1 to the right of the battery. Debug error displayed 00 (D0 - Late CPU Initialization) Supports 3-Way AMD CrossFire TechnologyĪdditional Information Date First AvailableĬons: 1. 1 x HDMI port, supporting a maximum resolution of 1 x DVI-D port, supporting a maximum resolution of Support The supported drivers for other operating systems would be available on the website if provided by vendor.Ģ x USB 2.0 connectors (supports additional 4 USB 2.0 ports)ġ x USB 3.1 Gen1 connector (supports additional 2 USB 3.1 Gen1 ports) * The Killer Network Manager is only available for Windows 7 and Windows 8/ 8.1 currently. ** The Turbo U.2 Host Card is not included, please purchase separately.ġ x Qualcomm Killer E2400 Gigabit LAN controller* Supports PCIe 3.0 x4 NVMe Mini-SAS SSD with Turbo U.2 Host Card** Supports PCIe 3.0 x4 and SATA 6Gb/s standards, 4.2cm/ 6cm/ 8cm length M.2 SSD cards *** SATAe port is backward compatible with SATA. Please refer to page 34 for M.2 slots with examples of various combination possibilities.

* M.2, SATA and SATAe ports maximum support 1 x M.2_PCIe + 6 x SATAs or 1x M.2_SATA + 1 x M.2_PCIe + 4 x SATAs.

Msi z170a killer network drivers